Add a Host by hand

You can add a Host without scanning a Pairing Code. Type its address and user, pick how Waycar signs in, and add Waycar’s key to the Host yourself. Waycar then runs its checks and asks you to trust the Host’s key.

Add the Host

1. Open the form:
   • With no Host yet, tap Add Manually under Scan to Pair.
   • In the Hosts sheet, tap Add Host.
   • If the scanner shows Camera Access Needed, or your device can’t scan codes, tap Add Manually there.
2. Under Host, fill in Address and User. Port starts at 22. Name (optional) is the label you see in Waycar. A Pairing Code always uses port 22, so add a Host whose SSH server listens on another port here and enter that Port. See Pair with a Pairing Code.
3. Under Authentication, pick a Method: Device Key, RSA Key, or Password.
4. Tap Save.

Let the Host accept your key

• Device Key: tap Copy authorized_keys Line and add that line to ~/.ssh/authorized_keys on the Host. Waycar makes this key on your device, and the private key stays in the Keychain.
• RSA Key: tap Copy RSA Public Key and register it wherever the Host accepts SSH identities. The Host must offer RSA-SHA2-512 signatures.
• Password: type the password. Waycar saves it when you save the Host.

See SSH keys and passwords.

Optional settings

• herdr Session: leave Session name blank for the default herdr session.
• Jump Host: fill in Jump Host address (optional) to reach a Host through another machine. Leave it blank to connect directly. See Jump Host.
• Mosh: Test Mosh on this Host only works for a Host whose key is already trusted, such as a paired Host or one that has connected before. For a new Host it ends with “Could not connect to test. The host key is not trusted”. Save the Host, trust its key on its page, then tap Test Mosh Support there. See mosh. A failed test doesn’t block saving; sessions use SSH whenever mosh fails.

Trust this Host?

When the Host’s page opens, Waycar asks Trust this Host? and shows the key fingerprint. Check it matches the Host’s key, then tap Trust. Pairing skips this step because the Pairing Code already carries the key. See Host keys and fingerprints.

Troubleshooting

• Save is dimmed. Save stays off until:
  • Address and User are filled in.
  • Port is a number from 1 to 65535. With a Jump Host address set, Jump Host port must be valid too.
  • Session name is blank, or uses only letters, digits, ., _ and -, up to 64 characters, and isn’t . or ...
  • With Password, a password is typed in. When you edit a Host that already used a password, a blank field keeps the saved one.
• Could not save the Host. Saving failed after you tapped Save. Try again.

After you save, the Host’s page runs checks and says what to fix. See A Host’s page and checks:

• “The Host rejected the device key.” Add this Host’s key line to ~/.ssh/authorized_keys on the Host.
• “The Host rejected the login. Check the username and password.”
• “Could not reach the Host over SSH. Check the address and port.”

More in Can’t connect to a Host.